| Installing a Flush Mount Rod Holder |
 |
| Saturday, 09 April 2011 06:52 |
|
Installing a flush mount rod holder is quick and surprisingly easy provided that you measure twice and cut once. You should have a little wiggle room for "oops" depending on the mounting surface of the particular modol that you are installing. However, making the mistake of rushing into this install will send the whole projuct sideways in a hurry.
Locate the area for the install. Keep in mind that this will be an oblong hole and is fairly large. You also need to consider the angle that you are going to want when finished this install.
I like to use a hole saw to make the initial cut. This removes 2/3 of the eyeballing procedure on the next cut. The closer and more exact that you can make your cuts goes a long way to the streangth and integrity of your hull and may effect your overall performance.
You will need to decide a general direction for your rod to point while in the holder. To do this, I used a broon handle and circled the kayak several times before I found a position that I was happy with. I marked the kayak at the center of where the broom stick was resting. This was my center point for my next cut. I eyeball approximately 3/8 of an inch out from that mark and draw a half circle back to my original circle cut. This flush mount rod hoder allowed me approximately 5/8 of oops room. Be sure to check yours for the same.
Once you have test fitted your flush mount, pre-drill for your rivots or well nuts. As always, adding a gasket, or forming your own with your favorite sealant isn't a bad idea. Simply tighten the rod holder down. You're ready to rock!
|
Login
Newsletter
Also of Interest
Most Popular
The Ultimate Home Made Kayak Fishing Trailer I really enjoy your magazine and I’m glad to see this sport catching on so much. Last winter, I got so hooked on kayak fishing that I bought two Hobie Outbacks and rigged them...
Buiding a Kai-Rack for Kayak They say that, "Necessity is the mother of invention," but in truth, sometimes a really bad case of cabin fever, combined with watching old Tim Allen’s Home Improvement...
Hummingbird Scupper Transducer Install on Ocean Torque Posts and DIY threads for this install are few and far between so I figured that I would keep a photo journal of how I made this install. I really didn't know what to...
Random
Predator 13 Rigging Mounting the FF. Given the relationship between OK and Hummingbird FFs, no surprise the boat is ready to receive a Hummingbird FF. I have taken a liking to my trusty...
Kayak Fishing "Rod Pod" I like the Rod Pod, but I'm sure you guys have heard reports of them leaking in the surf, this should take care of things. But, that wasn't the point of this project. I felt the...
Quick Release Anchor System for the Kayak This nifty quick release anchor system allows you to unhook your anchor with one had and fight the fish. The float keeps your line in sight for easy retrieval after you get your...
